Radius Rods for the Reinforced Torque Tube – Finally a Repaired Car

In order to lessen the chance of cracking the torque tube again, my solution includes radius rods.  Contemporary solutions by other car manufacturers included a wide range of supports, posts, rods & brackets.  In my quest to figure out what might work, I spent a bit of my time on my back under old cars of the period.  My solution was to mimic the model T, rather than install a solid bracket to the frame.

The brackets for the radius rods were installed just inboard of the spring mounts (shiny area on the axle shaft tube).

The final version had the radius rods under tension between the rear axle tubes and the collar around the front end of the drive shaft tube (torque tube).

Rear axle bracket.

Front collar radius rod bracket.

On May 10, 2026, Chris Presley, my son in law, and I rolled the repaired rear end up the hill to install it on the car.

Craig steers, Chris provides the power.

Craig, daughter Tori and her husband, Chris help roll the rear end into approximate position.

On May 12, 2026, I attached the rear-end to the car.

Aligning the drive shaft to insert into rear universal joint.

The springs were then bolted back onto the axle shafts, just outboard of the new (completely removable) radius rod brackets.

Radius rod bracket to the left of the attachment point for the rear springs.

On May 13, 2026, the repairs were completed and it was time to start up the car and see if our efforts had returned the Michigan to operation.

After a year of non-operation, the Michigan returns to service.

With the car back and running we look forward to new adventures in our time machine.

 

Leave a Reply

Your email address will not be published. Required fields are marked *